自動混凝土攪拌車制動分泵漏制動液或分泵管路折斷,可在分泵管路接頭處用鐵皮、銅皮做個小墊子,將管路堵死,再旋緊螺釘,或者將斷口夾扁、卷曲堵漏,使該輪不起制動用作。但這樣做可能會(huì )造成單邊制動,駕駛時要注意行駛情況。
If the brake cylinder of automatic concrete mixer leaks brake fluid or the cylinder pipeline is broken, use iron sheet and copper sheet as a small cushion at the joint of the cylinder pipeline to block the pipeline, and then tighten the screw, or clamp the fracture flat and curl to block the leakage, so that the wheel can not be used for braking. However, this may cause unilateral braking. Pay attention to the driving conditions when driving.
自動混凝土攪拌車制動總泵缺制動液,可用酒精或白酒代替,特殊情況下可用清水代替。自動混凝土攪拌車制動皮碗發漲,將發漲的皮碗放在熱水中浸泡10分鐘-20分鐘,將皮碗上的含油成分去掉,這樣就可以使皮碗恢復原來的尺寸。
The brake fluid of the automatic mixing truck is replaced by alcohol or baijiu. When the brake cup of automatic concrete mixer truck rises, soak the rising cup in hot water for 10-20 minutes, and remove the oil content on the cup, so that the cup can return to its original size.
自動混凝土攪拌車離合器摩擦片燒蝕打滑,對燒蝕不太嚴重的摩擦片,可翻面使用。如燒蝕嚴重,可用棉布或帆布數層(其厚度應與原摩擦片一致),用鋼絲或鐵絲穿過鋼片上的孔,使其固定。駕駛自動混凝土攪拌車時應做到起步平穩,換擋動作迅速。
The friction plate of the clutch of the automatic concrete mixer is ablated and skidded. The friction plate with less serious ablation can be used upside down. If the ablation is serious, several layers of cotton cloth or canvas can be used (its thickness should be consistent with the original friction plate), and steel wire or iron wire can be used to pass through the hole on the steel plate to fix it. When driving the automatic concrete mixer, it shall start smoothly and shift quickly.
橫拉桿球節斷損,在保險杠或其它不影響自動混凝土攪拌車行駛的地方,卸下一只與球節總長度相似的螺釘,取代斷損的球節,裝上轉向節臂與螺母后,將螺釘露出部分用錘子鉚好。三軸自動混凝土攪拌車差速器齒輪損壞,如中、后橋差速器損壞任何一只,都可將該橋傳動軸和半軸拆下,自動混凝土攪拌車繼續行駛。若前差速器損壞,可將自動混凝土攪拌車輪轂接合盤拆下后繼續行駛。
The tie rod ball joint is broken. In the bumper or other places that do not affect the driving of the automatic concrete mixer, remove a screw similar to the total length of the ball joint to replace the broken ball joint. After installing the steering knuckle arm and nut, rivet the exposed part of the screw with a hammer. The differential gear of the three axle automatic concrete mixer is damaged. If either the middle and rear axle differential is damaged, the transmission shaft and half shaft of the axle can be removed, and the automatic concrete mixer continues to drive. If the front differential is damaged, remove the hub adapter of the automatic concrete mixing wheel and continue driving.
This article is provided by the automatic concrete mixer. Our website is: http://www.akware.net We will provide you with services with wholehearted enthusiasm. Welcome to visit