RM新时代投资官网|首入球时间_自動攪拌車的變速器油面和油質如何檢測?_行業資訊_自動混凝土攪拌機知識_自動混凝土攪拌機_自動混凝土攪拌車廠家

站內搜索

自動混凝土攪拌機知識

公司新聞行業資訊

熱點

混凝土攪拌機油箱氣孔起到什么作用？

2020-08-17

自動上料攪拌車的使用方法

2022-01-10

高壓下，混凝土攪拌車行業需要更改嗎？

2021-09-22

如何防止自上料攪拌輸送一體機車身油箱體積變??？

2022-01-17

關于山汽

聯系人：劉老師

電話：400-879-1999

公司：山東山汽工程機械（集團）有限公司

地址：山東省萊州市206國道與308省道交叉口東南50米

自動攪拌車的變速器油面和油質如何檢測?

所屬分類：行業資訊發布時間：2021-06-10 來源：http://www.akware.net/ 瀏覽量：0

自動攪拌車的變速器也是一個非常重要的部件，我們應該如何檢測變速器中的油面和油質呢？

The transmission of automatic mixer is also a very important part. How should we detect the oil level and quality in the transmission?

在對變速器進行檢查或故障診斷前，要對變速器油面和油質進行檢查。把選擋手柄放在P位，將發動機在怠速時少運轉數分鐘，油液達到正常工作溫度，汽車必須停放在水平路面上，這樣才能確保在差速器和變速器之間的油面高度正常、穩定。

Before the inspection or fault diagnosis of the transmission, the oil level and quality of the transmission should be inspected first. Put the gear selection handle in position P, run the engine at idle speed for at least a few minutes, the oil reaches the normal working temperature, and the car must be parked on the horizontal road, so as to ensure the normal and stable oil level between the differential and the transmission.

帶油位標尺的自動變速器油位檢查的具體方法如下：

The specific methods for oil level inspection of automatic transmission with oil level gauge are as follows:

1、將自動攪拌車停放在水平地面上，并拉緊手制動。

1. Park the automatic mixer on the level ground and tighten the hand brake.

2、讓發動機怠速運轉數分鐘。

2. Let the engine idle for a few minutes.
全自動攪拌車

3、踩住制動踏板，將操縱手柄撥倒擋、前進擋等位置，并在每個擋位上停留幾秒鐘，使液力變矩器和所有換擋執行元件中都充滿液壓油。然后將操縱手柄撥停車擋位置。

3. Step on the brake pedal, turn the control handle to the reverse gear, forward gear and other positions, and stay in each gear for a few seconds, so that the hydraulic torque converter and all shift actuators are filled with hydraulic oil. Then turn the joystick to the park position.

4、從加油管內撥出自動變速器油尺，將擦干凈的油尺全部插入加油管再拔出，檢查油尺上的油面高度。

4. Pull out the automatic transmission oil dipstick from the oil filling pipe, insert all the cleaned oil dipstick into the oil filling pipe, and then pull it out to check the oil level on the oil dipstick.

以上就是自動攪拌車變速器油面和油質的檢測方法，如果還有不明白的問題歡迎來電詳詢。

The above is the automatic mixer transmission oil level and oil quality detection method, if you still do not understand the question, welcome to inquire.

上一頁：夏季如何防止混凝土攪拌車全自動攪拌車過熱？下一頁：小型自動混凝土攪拌機故障緊急維修應該怎么做？

熱門產品 / HOT PRODUCT