rm棋牌_自上料攪拌車的輪胎多久換一次？_行業資訊_自動混凝土攪拌機知識_自動混凝土攪拌機_自動混凝土攪拌車廠家

站內搜索

自動混凝土攪拌機知識

公司新聞行業資訊

熱點

自動混凝土攪拌機遇到活塞敲缸的處理方法!

2021-01-31

如何防止全自動攪拌車粘罐現象的出現？

2020-06-17

自動上料攪拌車的正確剎車步驟！

2021-02-15

如何避免全自動攪拌車堵料的問題？

2022-02-18

關于山汽

聯系人：劉老師

電話：400-879-1999

公司：山東山汽工程機械（集團）有限公司

地址：山東省萊州市206國道與308省道交叉口東南50米

自上料攪拌車的輪胎多久換一次？

所屬分類：行業資訊發布時間：2021-03-24 來源：http://www.akware.net/ 瀏覽量：0

隨著自上料攪拌車成本的持續提升，輪胎的也跟著上漲，如果使用不當導致非正常損耗，對車主的錢包來說是個打擊。那么自上料攪拌車的輪胎多久換一次呢？下面我們一起來了解一下。

With the continuous increase of the cost of the self feeding mixer, the price of the tires also increases. If improper use causes abnormal loss, it is a blow to the wallet of the owner. How often do you change the tires from the loading mixer? Now let's take a look.

1.輪胎胎面花紋深度

1. tread depth of tire

胎面花紋的厚度一定要大于1.6毫米，如果你經常駕車行駛在摩擦力低的濕滑路面上，盡量能保證胎面花紋厚度是上述數值的兩倍。你可以學習人士，購買一個計量器來測量胎面花紋的厚度；然而老駕駛員常使用一種廣為流傳的辦法來大致估計胎面花紋厚度，那就是拿出一枚一元硬幣，順著國徽頂端方向插入胎面溝壑中，因為硬幣邊緣到國徽頂端的距離在1到2毫米之間，所以如果這時還可以看到整個國徽標志，說明胎面花紋厚度已經不足。

The tread thickness must be greater than 1.6mm. If you drive frequently on a wet slippery road with low friction, try to ensure that the tread thickness is twice the above value. You can learn from professionals and buy a gauge to measure the tread thickness; however, the old driver often uses a widely used method to estimate the tread thickness roughly, that is to take out a dollar coin and insert it into the tread groove in the direction of the top of the national emblem, because the edge of the coin goes to the country The distance between the top of the emblem is between 1 and 2mm, so if the whole national emblem can be seen at this time, the tread pattern thickness is insufficient.

2.胎面花紋磨損指示線

2. tread pattern wear indicator line

新款輪胎比過去的老式產品多了一項人性化設計：胎面花紋磨損指示線。當輪胎非常新或磨損程度很低的情況下，這些指示線幾乎不會(huì )被發覺，但當磨損到達一定程度這些隱藏在胎面溝壑中的指示線就呈現出來。胎面花紋磨損指示線為扁平的橡膠條，與胎面縱向垂直鑲嵌在胎面溝壑中。當你檢查輪胎可以偶爾發現一到兩條指示線的時候，說明胎面花紋厚度已經減少了很多，這種情況下行駛在濕滑路面上就要格外小心了。如果輪胎上的幾乎所有指示線都清晰可見，意味著你需要盡快更換輪胎了。

The new tyre has a more humanized design than the old ones in the past: tread pattern wear indicator line. When the tires are very new or wear is low, these indicators are hardly detected, but when the wear reaches a certain extent, these indicators hidden in the tread gully appear. The tread pattern wear indicator line is flat rubber strip, and is vertically embedded in the tread groove vertically with the tread. When you check the tires and you can occasionally find one or two indicator lines, it means that the tread thickness has been reduced a lot, so you should be careful when driving on wet road. If almost all of the indicator lines on the tire are clearly visible, it means you need to change the tires as soon as possible.
自動混凝土攪拌車

3.輪胎側壁裂紋

3. crack on the sidewall of tire

輪胎上存在的問題并不是全部集中在胎面上，輪胎側壁也會(huì )出現一些毛病。通過觀察查找輪胎側壁上那些肉眼直接可見的裂痕和切口。這些細小的溝槽預示著輪胎上未來可能出現的漏氣裂縫，更糟的話甚引發輪胎的爆裂，這些輪胎故障都是我們希望避免的。所以在輪胎側壁裂紋看起來比較嚴重的時候，還是以快速度把車輛開往維修廠更換輪胎為上策。

The problems on the tire are not all concentrated on the tread, and some problems will occur on the sidewall of the tire. Observe and find the cracks and cuts on the sidewall of the tire that are directly visible to the naked eye. These tiny grooves indicate the possible future air leakage cracks on the tires, and even cause the burst of the tires, which we hope to avoid. So when the side wall crack of the tire appears to be serious, it is better to drive the vehicle to the repair factory and replace the tire at a fast speed.

4.輪胎上的凸起和起泡

4. bulge and blister on tire

有些情況下，輪胎的外表面會(huì )因為強度不夠，導致高出正常輪胎表面的凸起和起泡。這就如同血管中出現的動脈瘤，輪胎也面臨類似的狀況，如果你沒能及時把車輛送往維修廠檢測輪胎故障，胎面上強度不足的區域很有可能引發突然的爆裂，高速行車下的輪胎爆裂甚會(huì )導致駕乘人員出現嚴重的傷病。

In some cases, the outer surface of the tire will be raised and bubbled higher than the normal tire surface due to insufficient strength. This is like an aneurysm in the blood vessel, and the tire is facing similar conditions. If you fail to send the vehicle to the repair factory to detect the tire failure in time, the area with insufficient strength on the tread may cause sudden burst. The burst of tires under high speed driving may even cause serious injuries to the driver.

車輛前行過程中出現一定量的抖動是不可避免的，特別是在道路狀況較差的條件下。當你已經有了一定駕駛經驗的時候，你可以通過感受自己判斷出怎樣的抖動在合理范圍內，以及怎樣的抖動說明車輛存在故障。

It is inevitable that a certain amount of jitter occurs during the process of vehicle moving forward, especially in the condition of poor road conditions. When you have some driving experience, you can judge by yourself what kind of jitter is within a reasonable range and what jitter means the vehicle has a fault.

上一頁：如何自上料攪拌車零配件的噪音問題？下一頁：混凝土攪拌車發動機怠速判斷及辦法？

熱門產品 / HOT PRODUCT